Thermodynamic Steam Trap TD600 Series
Thermodynamic Steam Trap TD600 Series
The steam trap shall be a thermodynamic disc type with all stainless steel construction. Integral seat design and disc to be hardened for long service life. Unit shall be capable of installation in any orientation and self-draining when mounted vertically.
- High pressure applications up to 600 PSIG
- Hardened stainless steel seat and disc for extended service
life even at high pressure - Single trap will operate over the entire pressure range of
3.5-600 PSIG (recommended above 30 PSIG) - Suitable for superheated steam
- Freeze-proof when trap is piped in a vertical orientation for complete drainage of condensate
- Three-hole balanced discharge extends life of the seat area
- Trap will function in any orientation (horizontal preferred)
Couldn't load pickup availability
Typical Application
Typical Application
DRIP, TRACING: TD600 model steam traps are most commonly used in drip applications, such as draining condensate from steam mains and steam supply lines. They can also be used for steam tracing applications. These traps are suitable for outdoor applications that are subject to freezing as well as superheated steam conditions. They are compact and rugged with only a single moving part. If a trap with an integral strainer is desired, the TD600S is recommended. If a fully in-line repairable design is required, the TD700S or the UTD450 with Universal Quick-Change connector is recommended.
Limiting Operating Conditions
Limiting Operating Conditions
1) Maximum back pressure not to exceed 80% of inlet pressure (measured in absolute pressure) or trap may not close.
2) For optimum performance, recommended for operating pressure above 30 PSIG.
Download Data Sheet
Download Data Sheet
Share
